SQ2YBC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2YBC-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1787582346	309 Count	110 Count
1787580923	309 Count	110 Count
1787579123	264 Count	96 Count
1787577323	210 Count	77 Count
1787575523	134 Count	53 Count
1787573723	48 Count	17 Count
1787571923	1011 Count	347 Count
1787570123	969 Count	334 Count
1787568322	906 Count	312 Count
1787566522	854 Count	298 Count
1787564722	798 Count	278 Count
1787562922	752 Count	264 Count
1787561122	705 Count	248 Count
1787559322	646 Count	221 Count
1787557522	593 Count	198 Count
1787555723	550 Count	184 Count
1787553923	505 Count	166 Count
1787552123	457 Count	152 Count
1787550323	395 Count	130 Count
1787548522	348 Count	113 Count
1787546722	290 Count	94 Count
1787544922	227 Count	75 Count
1787543121	165 Count	56 Count
1787541321	108 Count	39 Count
1787539521	61 Count	23 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)