IZ5IOM-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ5IOM-15. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1787588605	47 Count	969 Count
1787586802	46 Count	947 Count
1787583195	44 Count	908 Count
1787581391	43 Count	885 Count
1787579588	42 Count	854 Count
1787577785	41 Count	830 Count
1787575981	40 Count	808 Count
1787574178	39 Count	781 Count
1787572374	38 Count	749 Count
1787570571	37 Count	728 Count
1787568809	36 Count	711 Count
1787567005	35 Count	681 Count
1787565201	34 Count	660 Count
1787563398	33 Count	643 Count
1787561594	32 Count	627 Count
1787559791	31 Count	611 Count
1787557987	30 Count	592 Count
1787556184	29 Count	576 Count
1787554380	28 Count	553 Count
1787552577	27 Count	530 Count
1787550774	26 Count	510 Count
1787548970	25 Count	490 Count
1787547207	24 Count	475 Count
1787545404	23 Count	454 Count
1787543601	22 Count	442 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)