IK1TTD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IK1TTD-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787875268	33 Count	107 Count	31 Count
1787873465	23 Count	71 Count	22 Count
1787871661	12 Count	35 Count	12 Count
1787869858	329 Count	1029 Count	300 Count
1787868055	317 Count	989 Count	289 Count
1787866252	305 Count	949 Count	278 Count
1787864449	293 Count	912 Count	267 Count
1787862646	282 Count	868 Count	257 Count
1787860843	271 Count	833 Count	247 Count
1787859040	259 Count	791 Count	236 Count
1787857237	250 Count	752 Count	228 Count
1787855470	239 Count	716 Count	218 Count
1787853667	228 Count	688 Count	208 Count
1787851864	215 Count	652 Count	196 Count
1787850061	204 Count	615 Count	186 Count
1787848258	192 Count	584 Count	175 Count
1787846455	180 Count	552 Count	164 Count
1787844652	169 Count	521 Count	154 Count
1787842849	158 Count	484 Count	144 Count
1787841046	146 Count	448 Count	133 Count
1787839242	134 Count	412 Count	122 Count
1787837439	124 Count	377 Count	113 Count
1787835636	112 Count	340 Count	102 Count
1787833873	102 Count	310 Count	93 Count
1787832070	91 Count	277 Count	83 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)