G1RVX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object G1RVX-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1787864054	58 Count	38 Count	38 Count
1787862248	55 Count	36 Count	36 Count
1787860446	52 Count	34 Count	34 Count
1787858645	49 Count	32 Count	32 Count
1787856839	46 Count	30 Count	30 Count
1787855039	43 Count	28 Count	28 Count
1787853233	40 Count	26 Count	26 Count
1787851429	37 Count	24 Count	24 Count
1787849626	34 Count	22 Count	22 Count
1787847859	31 Count	20 Count	20 Count
1787846055	28 Count	18 Count	18 Count
1787844252	25 Count	16 Count	16 Count
1787842448	22 Count	14 Count	14 Count
1787840645	20 Count	13 Count	13 Count
1787838842	18 Count	12 Count	12 Count
1787837038	15 Count	10 Count	10 Count
1787835235	12 Count	8 Count	8 Count
1787833431	9 Count	6 Count	6 Count
1787831628	6 Count	4 Count	4 Count
1787829824	3 Count	2 Count	2 Count
1787828021	0 Count	0 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)