SO2MK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SO2MK-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1788406118	129 Count	529 Count	10 Count
1788402518	117 Count	484 Count	10 Count
1788398917	105 Count	438 Count	10 Count
1788395316	93 Count	386 Count	10 Count
1788391716	81 Count	339 Count	10 Count
1788388115	69 Count	277 Count	10 Count
1788384514	57 Count	233 Count	10 Count
1788380914	45 Count	184 Count	10 Count
1788377313	27 Count	119 Count	4 Count
1788362876	18 Count	725 Count	15 Count
1788361193	17 Count	612 Count	15 Count
1788360974	16 Count	594 Count	15 Count
1788357373	2 Count	265 Count	2 Count
1788353772	22 Count	1017 Count	19 Count
1788350172	5 Count	748 Count	3 Count
1788346571	1 Count	493 Count	0 Count
1788342976	0 Count	244 Count	0 Count
1788339375	30 Count	1229 Count	26 Count
1788335774	29 Count	962 Count	26 Count
1788332174	28 Count	712 Count	26 Count
1788328573	19 Count	431 Count	18 Count
1788301544	37 Count	693 Count	27 Count
1788297942	36 Count	643 Count	27 Count
1788294341	35 Count	586 Count	27 Count
1788290740	34 Count	531 Count	27 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)