SP2WM-17 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WM-17. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1788572575	226 Count	359 Count	84 Count
1788571674	225 Count	354 Count	84 Count
1788570773	224 Count	344 Count	84 Count
1788569872	223 Count	334 Count	84 Count
1788568972	222 Count	328 Count	84 Count
1788568087	217 Count	322 Count	84 Count
1788567186	216 Count	317 Count	84 Count
1788566285	215 Count	312 Count	84 Count
1788565384	214 Count	304 Count	84 Count
1788564483	213 Count	297 Count	84 Count
1788563583	212 Count	292 Count	84 Count
1788562682	211 Count	287 Count	84 Count
1788561781	210 Count	280 Count	84 Count
1788560880	209 Count	271 Count	84 Count
1788559979	208 Count	257 Count	84 Count
1788559078	207 Count	248 Count	84 Count
1788558178	206 Count	244 Count	84 Count
1788557277	205 Count	236 Count	84 Count
1788556376	204 Count	228 Count	84 Count
1788555476	203 Count	223 Count	84 Count
1788554575	202 Count	218 Count	84 Count
1788553674	201 Count	213 Count	84 Count
1788551873	199 Count	201 Count	84 Count
1788550972	198 Count	195 Count	84 Count
1788550071	197 Count	189 Count	84 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)