F5ODP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ODP-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	V_Bat*
1781434233	177 Count	4.21 VDC
1781430626	140 Count	4.2 VDC
1781427017	102 Count	4.25 VDC
1781423409	63 Count	4.21 VDC
1781423333	59 Count	4.25 VDC
1781422839	55 Count	4.17 VDC
1781421653	40 Count	4.26 VDC
1781128899	986 Count	4.19 VDC
1781125291	944 Count	4.16 VDC
1781118075	850 Count	4.22 VDC
1781114664	812 Count	4.23 VDC
1781111057	775 Count	4.26 VDC
1781103840	701 Count	4.22 VDC
1781100232	663 Count	4.27 VDC
1781096624	627 Count	4.24 VDC
1781093016	589 Count	4.23 VDC
1781089407	550 Count	4.2 VDC
1781085799	512 Count	4.23 VDC
1781082191	473 Count	4.19 VDC
1781078583	434 Count	4.23 VDC
1781074975	397 Count	4.21 VDC
1781071365	359 Count	4.21 VDC
1781067757	321 Count	4.24 VDC
1781064148	284 Count	4.23 VDC
1781060540	247 Count	4.26 VDC

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)