VE6AGD-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE6AGD-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Batt*	RegTemp*
1761597709	11.49 volts	81 degF
1761597466	11.51 volts	76 degF
1761597220	11.49 volts	75 degF
1761586521	11.95 volts	86 degF
1761585913	11.12 volts	84 degF
1761585609	11.92 volts	97 degF
1761581950	11.12 volts	81 degF
1761578251	11.88 volts	77 degF
1761497036	11.01 volts	77 degF
1761496956	11.01 volts	79 degF
1761439695	11.21 volts	79 degF
1761439453	11.81 volts	81 degF
1761433443	10.94 volts	85 degF
1761433158	11.9 volts	94 degF
1761432567	11.88 volts	103 degF
1761431327	11.99 volts	105 degF
1761431024	11.99 volts	103 degF
1761430727	11.88 volts	98 degF
1761430524	11.99 volts	82 degF
1761430178	11.07 volts	70 degF
1761416144	11.24 volts	92 degF
1761415184	11.83 volts	111 degF
1761414883	11.76 volts	111 degF
1761413120	11.95 volts	83 degF
1761412946	11.85 volts	85 degF

*Used Equation Coefficients:

Batt: 0, 0.01, 0

RegTemp: 0, 1, 0

: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)