IU1OPQ-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU1OPQ-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789962287	445 Count	64 Count
1789960484	444 Count	64 Count
1789958681	443 Count	64 Count
1789956878	442 Count	64 Count
1789955075	441 Count	64 Count
1789953272	440 Count	64 Count
1789951469	439 Count	64 Count
1789949666	438 Count	64 Count
1789946060	436 Count	64 Count
1789944257	435 Count	64 Count
1789942488	430 Count	64 Count
1789940685	429 Count	64 Count
1789938882	428 Count	64 Count
1789937079	427 Count	64 Count
1789935276	426 Count	64 Count
1789933473	425 Count	64 Count
1789931670	424 Count	64 Count
1789929867	423 Count	64 Count
1789928064	422 Count	64 Count
1789926261	421 Count	64 Count
1789924458	420 Count	64 Count
1789922672	419 Count	64 Count
1789920891	414 Count	64 Count
1789919084	413 Count	64 Count
1789917295	412 Count	64 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)