IN3EJX-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IN3EJX-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789951045	107 Count	639 Count
1789949242	106 Count	632 Count
1789947438	105 Count	624 Count
1789945635	104 Count	617 Count
1789943831	103 Count	610 Count
1789942028	102 Count	601 Count
1789940264	97 Count	594 Count
1789938460	96 Count	586 Count
1789936657	95 Count	578 Count
1789934853	94 Count	569 Count
1789933049	93 Count	561 Count
1789931246	92 Count	552 Count
1789929442	91 Count	545 Count
1789927639	90 Count	537 Count
1789925835	89 Count	530 Count
1789924032	88 Count	523 Count
1789922228	87 Count	514 Count
1789920425	86 Count	507 Count
1789919989	81 Count	503 Count
1789918185	80 Count	495 Count
1789916382	79 Count	486 Count
1789914578	78 Count	478 Count
1789912775	77 Count	470 Count
1789910972	76 Count	462 Count
1789909168	75 Count	454 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)