SQ3MVA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3MVA-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789942190	174 Count	159 Count	159 Count
1789941289	163 Count	149 Count	149 Count
1789940388	152 Count	139 Count	139 Count
1789939487	142 Count	130 Count	130 Count
1789938587	131 Count	120 Count	120 Count
1789937686	120 Count	110 Count	110 Count
1789936785	109 Count	100 Count	100 Count
1789935884	98 Count	90 Count	90 Count
1789934984	87 Count	80 Count	80 Count
1789934083	76 Count	70 Count	70 Count
1789933182	65 Count	60 Count	60 Count
1789932281	54 Count	50 Count	50 Count
1789931381	43 Count	40 Count	40 Count
1789930480	32 Count	30 Count	30 Count
1789929579	21 Count	20 Count	20 Count
1789928678	10 Count	10 Count	10 Count
1789927777	1009 Count	914 Count	914 Count
1789926877	999 Count	905 Count	905 Count
1789925976	988 Count	895 Count	895 Count
1789925075	978 Count	886 Count	886 Count
1789924174	967 Count	876 Count	876 Count
1789923273	956 Count	866 Count	866 Count
1789922372	945 Count	856 Count	856 Count
1789921471	934 Count	846 Count	846 Count
1789920571	923 Count	836 Count	836 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)