SP2HCC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCC-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789956883	600 Count	895 Count	516 Count
1789955382	599 Count	895 Count	516 Count
1789953881	598 Count	895 Count	516 Count
1789952380	597 Count	895 Count	516 Count
1789950879	596 Count	895 Count	516 Count
1789950291	595 Count	895 Count	516 Count
1789948790	594 Count	895 Count	516 Count
1789947290	593 Count	895 Count	516 Count
1789945789	592 Count	895 Count	516 Count
1789944288	591 Count	895 Count	516 Count
1789942787	590 Count	895 Count	516 Count
1789941286	589 Count	895 Count	516 Count
1789939785	588 Count	895 Count	516 Count
1789938284	587 Count	895 Count	516 Count
1789936783	586 Count	895 Count	516 Count
1789935283	585 Count	895 Count	516 Count
1789933782	584 Count	895 Count	516 Count
1789932281	583 Count	895 Count	516 Count
1789930780	582 Count	895 Count	516 Count
1789929279	581 Count	895 Count	516 Count
1789903767	578 Count	895 Count	516 Count
1789902267	577 Count	895 Count	516 Count
1789900766	576 Count	895 Count	516 Count
1789899265	575 Count	895 Count	516 Count
1789897764	574 Count	895 Count	516 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)