This is the latest recevied telemetry packets stored in our database for station/object DO1DW-83. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
Press*
Temp.in*
Hum*
eGAS*
Temp.out*
1789951947
975 hPa
11 C deg
66.2 %
88 -
0 C deg
1789942794
974.8 hPa
11.9 C deg
64.4 %
87 -
0 C deg
1789940962
974.6 hPa
12.3 C deg
64 %
85 -
0 C deg
1789929975
972.9 hPa
14.1 C deg
64.6 %
76 -
0 C deg
1789906176
968 hPa
17.2 C deg
63 %
63 -
0 C deg
1789902512
968.2 hPa
17.3 C deg
62.1 %
63 -
0 C deg
1789875056
967.1 hPa
17.6 C deg
59 %
65 -
0 C deg
1789821992
966.6 hPa
23.3 C deg
59.5 %
42 -
0 C deg
1789792663
964.6 hPa
13.7 C deg
58.5 %
88 -
0 C deg
1789750556
962.5 hPa
19.5 C deg
57.8 %
61 -
0 C deg
1789748730
962.7 hPa
20.3 C deg
57.9 %
58 -
0 C deg
*Used Equation Coefficients:
Press: 0, 1, 0
Temp.in: 0, 1, 0
Hum: 0, 1, 0
eGAS: 0, 1, 0
Temp.out: 0, 1, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)