F1ZXR-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1ZXR-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	tempera*	volts*
1789963247	1280 T/100	1 V
1789962945	1280 T/100	1 V
1789962649	1280 T/100	1 V
1789962349	1280 T/100	1 V
1789962052	1280 T/100	1 V
1789961747	1280 T/100	1 V
1789961451	1280 T/100	1 V
1789961149	1280 T/100	1 V
1789960846	1280 T/100	1 V
1789960549	1280 T/100	1 V
1789960242	1280 T/100	1 V
1789959943	1280 T/100	1 V
1789959644	1280 T/100	1 V
1789959353	1280 T/100	1 V
1789959045	1280 T/100	1 V
1789958743	1280 T/100	1 V
1789958448	1280 T/100	1 V
1789958145	1280 T/100	1 V
1789957840	1280 T/100	1 V
1789957544	1280 T/100	1 V
1789957258	1280 T/100	1 V
1789956942	1280 T/100	1 V
1789956643	1280 T/100	1 V
1789956340	1280 T/100	1 V
1789956042	1280 T/100	1 V

*Used Equation Coefficients:

tempera: 0, 10, 0

Battery: 0, 10, 0

alim: 0, 1, 0

volts: 0, 0, 1

temp: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)