This is the latest recevied telemetry packets stored in our database for station/object XE1EL-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
Vin*
Rx1h*
Dg1h*
Eff1h*
A5*
1761580252
15.01 Volt
70 Pkt
0 Pkt
61 Pcnt
0 None
1761576517
15.01 Volt
100 Pkt
10 Pkt
58 Pcnt
0 None
1761401509
15.01 Volt
70 Pkt
0 Pkt
65 Pcnt
0 None
1761319590
14.77 Volt
50 Pkt
0 Pkt
60 Pcnt
0 None
1761232086
15.01 Volt
70 Pkt
0 Pkt
81 Pcnt
0 None
1761055215
15.01 Volt
40 Pkt
0 Pkt
61 Pcnt
0 None
*Used Equation Coefficients:
Vin: 0, 0.079, 0
Rx1h: 0, 10, 0
Dg1h: 0, 10, 0
Eff1h: 0, 1, 0
A5: 0, 0, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)