VK3XEM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK3XEM-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784716451	66 Count	8 Count	8 Count
1784715547	65 Count	8 Count	8 Count
1784714642	64 Count	8 Count	8 Count
1784713737	63 Count	8 Count	8 Count
1784712833	62 Count	8 Count	8 Count
1784711929	61 Count	8 Count	8 Count
1784711025	60 Count	8 Count	8 Count
1784710119	59 Count	8 Count	8 Count
1784709223	58 Count	8 Count	8 Count
1784708311	57 Count	8 Count	8 Count
1784707407	56 Count	8 Count	8 Count
1784706502	55 Count	8 Count	8 Count
1784705598	54 Count	8 Count	8 Count
1784704694	53 Count	8 Count	8 Count
1784703790	52 Count	8 Count	8 Count
1784702885	51 Count	8 Count	8 Count
1784701981	50 Count	8 Count	8 Count
1784701077	49 Count	8 Count	8 Count
1784700173	48 Count	8 Count	8 Count
1784699268	47 Count	8 Count	8 Count
1784698364	46 Count	8 Count	8 Count
1784697460	45 Count	8 Count	8 Count
1784696555	44 Count	8 Count	8 Count
1784695753	42 Count	7 Count	7 Count
1784694848	41 Count	7 Count	7 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)