SP2OSA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789965886	72 Count	621 Count	42 Count
1789964085	70 Count	597 Count	41 Count
1789962284	53 Count	534 Count	25 Count
1789960484	47 Count	484 Count	20 Count
1789958690	41 Count	460 Count	19 Count
1789956890	39 Count	437 Count	18 Count
1789955089	37 Count	413 Count	17 Count
1789953288	35 Count	393 Count	16 Count
1789951487	33 Count	365 Count	15 Count
1789949687	31 Count	342 Count	14 Count
1789947886	29 Count	319 Count	13 Count
1789946085	27 Count	291 Count	12 Count
1789944285	25 Count	268 Count	11 Count
1789942484	23 Count	245 Count	10 Count
1789940683	21 Count	214 Count	9 Count
1789938883	19 Count	185 Count	8 Count
1789937089	13 Count	163 Count	7 Count
1789935289	11 Count	142 Count	6 Count
1789933488	9 Count	119 Count	5 Count
1789931687	7 Count	98 Count	4 Count
1789929887	5 Count	71 Count	3 Count
1789928086	3 Count	48 Count	2 Count
1789926285	1 Count	27 Count	1 Count
1789924484	93 Count	1007 Count	43 Count
1789922684	91 Count	987 Count	42 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)