MB7USU-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7USU-5. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1788639529	224 Count	351 Count	172 Count
1788637728	220 Count	346 Count	169 Count
1788635927	216 Count	341 Count	166 Count
1788634127	212 Count	336 Count	163 Count
1788632326	208 Count	331 Count	160 Count
1788630525	203 Count	325 Count	156 Count
1788628725	199 Count	320 Count	153 Count
1788626924	195 Count	315 Count	150 Count
1788625123	191 Count	310 Count	147 Count
1788623323	187 Count	305 Count	144 Count
1788621522	182 Count	299 Count	140 Count
1788619731	178 Count	294 Count	137 Count
1788617931	174 Count	289 Count	134 Count
1788616130	170 Count	283 Count	131 Count
1788614329	163 Count	269 Count	125 Count
1788612528	158 Count	261 Count	121 Count
1788610728	155 Count	257 Count	119 Count
1788608927	152 Count	253 Count	117 Count
1788607126	148 Count	248 Count	114 Count
1788605326	144 Count	243 Count	111 Count
1788603525	139 Count	237 Count	107 Count
1788598126	124 Count	184 Count	95 Count
1788596326	120 Count	179 Count	92 Count
1788594525	113 Count	138 Count	86 Count
1788592724	109 Count	133 Count	83 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)