F4CVH-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4CVH-5. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1777184755	31	-109	999	712	589
1777183053	31	-109	999	713	589
1777181352	28	-108	999	713	589
1777179646	31	-108	999	712	589
1777177944	31	-108	999	711	588
1777176244	27	-108	999	710	588
1777174538	31	-108	999	711	588
1777172836	31	-108	999	711	591
1777171133	31	-108	999	711	587
1777169431	31	-108	999	711	587
1777167729	31	-108	998	710	587
1777166026	31	-108	999	711	590
1777164324	31	-107	999	711	590
1777162620	31	-107	999	711	587
1777160916	31	-107	999	711	587
1777159214	31	-107	999	710	586
1777155809	31	-107	999	710	586
1777154107	31	-107	999	710	586
1777152402	31	-107	999	710	586
1777150700	31	-107	999	709	585
1777148996	31	-107	999	710	586
1777147294	31	-107	999	710	585
1777145592	31	-107	999	709	584
1777143890	31	-107	999	709	584
1777142185	31	-107	999	709	585

*Used Equation Coefficients:

Value1: 0, 1, -126

Value2: 0, 1, -126

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)