SP6RGZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RGZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784675280	952 Count	182 Count	182 Count
1784673479	951 Count	182 Count	182 Count
1784671679	950 Count	182 Count	182 Count
1784669878	949 Count	182 Count	182 Count
1784668077	948 Count	182 Count	182 Count
1784666276	947 Count	182 Count	182 Count
1784664476	946 Count	182 Count	182 Count
1784662675	945 Count	182 Count	182 Count
1784660884	944 Count	182 Count	182 Count
1784659083	943 Count	182 Count	182 Count
1784657282	942 Count	182 Count	182 Count
1784655481	941 Count	182 Count	182 Count
1784653680	940 Count	182 Count	182 Count
1784651879	939 Count	182 Count	182 Count
1784650078	938 Count	182 Count	182 Count
1784648278	937 Count	182 Count	182 Count
1784646477	936 Count	182 Count	182 Count
1784644676	935 Count	182 Count	182 Count
1784642876	934 Count	182 Count	182 Count
1784641075	933 Count	182 Count	182 Count
1784639283	932 Count	182 Count	182 Count
1784637482	931 Count	182 Count	182 Count
1784635681	926 Count	178 Count	178 Count
1784633881	925 Count	178 Count	178 Count
1784632080	924 Count	178 Count	178 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)