WA6ODP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WA6ODP-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	DC*	PC Board*	CPU*	Ambient*
1787570213	1374	91.3	50.5	78
1787569649	1372	91.3	50.5	77.9
1787569013	1372	91.2	50.5	77.9
1787568448	1372	91.2	50.5	78
1787567813	1371	91.2	50.5	78.1
1787567247	1371	91.2	50.5	78.1
1787566612	1371	91.2	49.9	77.9
1787566048	1369	91.2	49.9	77.8
1787565413	1374	91.1	49.9	77.8
1787564849	1369	91	50.5	77.7
1787564213	1371	91	49.4	77.4
1787563647	1371	91	49.9	77.3
1787563012	1371	91	50.5	77.2
1787562449	1369	91.1	49.9	77.2
1787561812	1371	91.1	49.9	77.3
1787561249	1369	91.3	49.9	77.4
1787560613	1371	91.3	50.5	77.6
1787560047	1371	91.5	50.5	77.8
1787559413	1371	91.5	50.5	77.8
1787558850	1375	91.5	50.5	77.8
1787558212	1371	91.5	50.5	77.8
1787557648	1371	91.6	50.5	77.8
1787556448	1371	91.8	50.5	77.9
1787555813	1375	92	50.5	78
1787555249	1371	92	50.5	78.1

*Used Equation Coefficients:

DC: 0, 1, 1000

PC Board: 0, 0.1, 0

CPU: 0, 0.1, 0

Ambient: 0, 0.1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)