SP2OSA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789953551	870 Count	113 Count	113 Count
1789952651	869 Count	113 Count	113 Count
1789951750	868 Count	113 Count	113 Count
1789949047	865 Count	113 Count	113 Count
1789948146	864 Count	113 Count	113 Count
1789947245	863 Count	113 Count	113 Count
1789946344	862 Count	113 Count	113 Count
1789945465	861 Count	113 Count	113 Count
1789944564	860 Count	113 Count	113 Count
1789943663	859 Count	113 Count	113 Count
1789942762	858 Count	113 Count	113 Count
1789941861	857 Count	113 Count	113 Count
1789940960	856 Count	113 Count	113 Count
1789940058	855 Count	113 Count	113 Count
1789939158	854 Count	113 Count	113 Count
1789938257	853 Count	113 Count	113 Count
1789937356	852 Count	113 Count	113 Count
1789936455	851 Count	113 Count	113 Count
1789935554	850 Count	113 Count	113 Count
1789934653	849 Count	113 Count	113 Count
1789933752	848 Count	113 Count	113 Count
1789932851	847 Count	113 Count	113 Count
1789931950	846 Count	113 Count	113 Count
1789931050	845 Count	113 Count	113 Count
1789930166	844 Count	113 Count	113 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)