OH2TI Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OH2TI. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	rain*
1784671582	13.3 V	13.5 mm
1784671247	13.3 V	13.5 mm
1784670418	13.4 V	13.5 mm
1784669720	13.4 V	13.5 mm
1784668828	13.4 V	13.5 mm
1784668258	13.3 V	13.5 mm
1784667795	13.4 V	13.5 mm
1784667460	13.4 V	13.5 mm
1784666842	13.4 V	13.5 mm
1784666230	13.3 V	13.5 mm
1784665588	13.4 V	13.5 mm
1784665057	13.4 V	13.5 mm
1784664277	13.4 V	13.5 mm
1784663435	13.4 V	13.5 mm
1784662798	13.4 V	13.5 mm
1784661955	13.4 V	13.5 mm
1784661115	13.3 V	13.5 mm
1784660587	13.4 V	13.5 mm
1784659735	13.4 V	13.5 mm
1784659295	13.3 V	13.5 mm
1784658945	13.4 V	13.5 mm
1784658055	13.4 V	13.5 mm
1784657298	13.4 V	13.5 mm
1784656537	13.4 V	13.5 mm
1784655800	13.4 V	13.4 mm

*Used Equation Coefficients:

Vin: 0, 0.1, 0

rain: 0, 0.1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)