WA6ODP-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WA6ODP-4. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*
1776867484	1391	53.7	27.9	45
1776867181	1392	53.5	28.4	44.8
1776866281	1392	53.5	27.9	44.7
1776865381	1391	53.3	27.9	44.5
1776865082	1392	53.3	27.3	44.5
1776863883	1392	53.4	27.9	44.3
1776863581	1392	53.4	27.9	44.4
1776862682	1391	53.5	27.9	44.6
1776861781	1392	53.6	27.9	44.7
1776861482	1392	53.7	27.9	44.6
1776860282	1392	53.8	27.9	45
1776859981	1392	53.9	27.9	45
1776859081	1391	54	27.9	45.2
1776858181	1391	54	27.9	45.3
1776857882	1392	54	27.9	45.2
1776856682	1392	54	27.9	45.2
1776856391	1392	53.9	27.9	45.2
1776855481	1392	53.9	27.9	45.2
1776854581	1392	54	28.4	45
1776854282	1392	54	27.9	45.2
1776853086	1391	54.2	27.9	45.3
1776852781	1392	54.2	28.4	45.3
1776851881	1392	54	27.9	45
1776850981	1392	54.3	28.4	45.2
1776850682	1392	54.3	27.9	45.2

*Used Equation Coefficients:

Value1: 0, 1, 1000

Value2: 0, 0.1, 0

Value3: 0, 0.1, 0

Value4: 0, 0.1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)