XE2AD-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XE2AD-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Temp*
1788571474	13.83 Volt	27 C
1788570875	13.83 Volt	27 C
1788570874	13.83 Volt	27 C
1788570275	13.83 Volt	27 C
1788570274	13.83 Volt	27 C
1788569675	13.83 Volt	27 C
1788569674	13.83 Volt	27 C
1788569075	13.83 Volt	27.5 C
1788569074	13.83 Volt	27.5 C
1788568475	13.83 Volt	27 C
1788568474	13.83 Volt	27 C
1788567875	13.83 Volt	27.5 C
1788567874	13.83 Volt	27.5 C
1788567274	13.83 Volt	27.5 C
1788566675	13.83 Volt	27.5 C
1788566674	13.83 Volt	27.5 C
1788566075	13.83 Volt	27 C
1788566074	13.83 Volt	27 C
1788565475	13.83 Volt	27 C
1788565474	13.83 Volt	27 C
1788564875	13.83 Volt	27 C
1788564874	13.83 Volt	27 C
1788564336	13.9 Volt	27 C
1788564334	13.9 Volt	27 C
1788563852	13.9 Volt	27 C

*Used Equation Coefficients:

Vin: 0, 0.079, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

Temp: 0, 0.5, -64

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)