MB7VZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7VZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Mains*	Battery*
1772960740	14.11 V	13.61 V
1772958938	14.11 V	13.61 V
1772955334	14.11 V	13.61 V
1772951731	14.11 V	13.61 V
1772949929	14.11 V	13.61 V
1772944525	14.11 V	13.61 V
1772940920	14.11 V	13.61 V
1772939119	14.11 V	13.61 V
1772937318	14.11 V	13.61 V
1772933714	14.11 V	13.61 V
1772930110	14.11 V	13.61 V
1772928308	14.11 V	13.61 V
1772926506	14.11 V	13.61 V
1772924705	14.11 V	13.61 V
1772921102	14.11 V	13.61 V
1772919300	14.11 V	13.61 V
1772917497	14.11 V	13.61 V
1772915696	14.11 V	13.61 V
1772913894	14.11 V	13.61 V
1772912092	14.11 V	13.61 V
1772908488	14.11 V	13.61 V
1772904885	14.11 V	13.61 V
1772901281	14.11 V	13.61 V
1772894075	14.11 V	13.61 V
1772890472	14.11 V	13.61 V

*Used Equation Coefficients:

Mains: 0, 0.0993382, 0

Battery: 0, 0.0986131, 0

PktRcd: 0, 1, 0

Temp: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)