S51ZK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object S51ZK-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787588910	579 Count	110 Count	105 Count
1787585326	578 Count	110 Count	105 Count
1787581723	577 Count	110 Count	105 Count
1787578120	576 Count	110 Count	105 Count
1787574516	568 Count	103 Count	98 Count
1787570913	567 Count	103 Count	98 Count
1787567310	566 Count	103 Count	98 Count
1787563725	565 Count	103 Count	98 Count
1787560121	564 Count	103 Count	98 Count
1787556518	563 Count	103 Count	98 Count
1787552915	562 Count	103 Count	98 Count
1787549312	561 Count	103 Count	98 Count
1787545708	560 Count	103 Count	98 Count
1787542199	559 Count	103 Count	98 Count
1787538523	558 Count	103 Count	98 Count
1787534920	557 Count	103 Count	98 Count
1787531317	556 Count	103 Count	98 Count
1787527714	555 Count	103 Count	98 Count
1787524110	554 Count	103 Count	98 Count
1787520523	553 Count	103 Count	98 Count
1787516919	552 Count	103 Count	98 Count
1787513316	551 Count	103 Count	98 Count
1787509713	550 Count	103 Count	98 Count
1787506110	549 Count	103 Count	98 Count
1787502507	547 Count	102 Count	97 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)