SV3GCB-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV3GCB-13. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1788675782	97 Count	111 Count	74 Count
1788674875	95 Count	106 Count	73 Count
1788673968	92 Count	102 Count	71 Count
1788673062	90 Count	100 Count	70 Count
1788672162	81 Count	91 Count	62 Count
1788671247	75 Count	86 Count	57 Count
1788670341	72 Count	83 Count	55 Count
1788669434	69 Count	80 Count	53 Count
1788668527	66 Count	77 Count	51 Count
1788667620	58 Count	69 Count	44 Count
1788666714	48 Count	57 Count	35 Count
1788665807	38 Count	47 Count	26 Count
1788664900	32 Count	40 Count	21 Count
1788663994	23 Count	29 Count	13 Count
1788663087	21 Count	27 Count	12 Count
1788662180	19 Count	25 Count	11 Count
1788661274	17 Count	22 Count	10 Count
1788660367	15 Count	20 Count	9 Count
1788659460	13 Count	18 Count	8 Count
1788658554	9 Count	12 Count	5 Count
1788657807	7 Count	9 Count	4 Count
1788656901	5 Count	7 Count	3 Count
1788655994	3 Count	5 Count	2 Count
1788655087	1 Count	3 Count	1 Count
1788654180	918 Count	1002 Count	578 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)