OK1FWG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1FWG-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784702253	667 Count	356 Count	236 Count
1784700450	660 Count	350 Count	230 Count
1784698647	659 Count	341 Count	230 Count
1784696844	658 Count	323 Count	230 Count
1784695041	657 Count	323 Count	230 Count
1784691435	655 Count	323 Count	230 Count
1784687829	653 Count	323 Count	230 Count
1784684222	651 Count	323 Count	230 Count
1784682419	650 Count	323 Count	230 Count
1784680616	649 Count	323 Count	230 Count
1784677010	647 Count	323 Count	230 Count
1784675207	646 Count	323 Count	230 Count
1784669798	643 Count	323 Count	230 Count
1784667995	642 Count	323 Count	230 Count
1784666192	641 Count	323 Count	230 Count
1784664389	640 Count	323 Count	230 Count
1784662586	639 Count	323 Count	230 Count
1784660783	638 Count	323 Count	230 Count
1784658980	637 Count	323 Count	230 Count
1784655374	623 Count	311 Count	218 Count
1784653571	622 Count	311 Count	218 Count
1784651768	621 Count	311 Count	218 Count
1784649965	612 Count	303 Count	210 Count
1784648162	611 Count	303 Count	210 Count
1784646359	610 Count	303 Count	210 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)