SQ9SIM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9SIM-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784684434	664 Count	252 Count	189 Count
1784680832	662 Count	252 Count	189 Count
1784677231	660 Count	252 Count	189 Count
1784673629	658 Count	252 Count	189 Count
1784670061	656 Count	252 Count	189 Count
1784666459	654 Count	252 Count	189 Count
1784662857	652 Count	252 Count	189 Count
1784659256	650 Count	252 Count	189 Count
1784655654	648 Count	252 Count	189 Count
1784652052	646 Count	252 Count	189 Count
1784648451	644 Count	252 Count	189 Count
1784644849	642 Count	252 Count	189 Count
1784641248	640 Count	252 Count	189 Count
1784637646	636 Count	250 Count	187 Count
1784634045	630 Count	246 Count	183 Count
1784630443	624 Count	242 Count	179 Count
1784627012	620 Count	240 Count	177 Count
1784623435	616 Count	238 Count	175 Count
1784619833	610 Count	234 Count	171 Count
1784616232	604 Count	230 Count	167 Count
1784612649	598 Count	226 Count	163 Count
1784609047	592 Count	222 Count	159 Count
1784605445	590 Count	222 Count	159 Count
1784601844	588 Count	222 Count	159 Count
1784598242	586 Count	222 Count	159 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)