WB9TLH-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WB9TLH-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Eff1h*	Efftot*
1784698183	100 Pcnt	47 Pcnt
1784696381	100 Pcnt	47 Pcnt
1784694579	100 Pcnt	47 Pcnt
1784692777	100 Pcnt	47 Pcnt
1784690976	100 Pcnt	47 Pcnt
1784689174	100 Pcnt	47 Pcnt
1784687372	100 Pcnt	47 Pcnt
1784685570	0 Pcnt	47 Pcnt
1784683769	0 Pcnt	47 Pcnt
1784681967	100 Pcnt	47 Pcnt
1784680165	100 Pcnt	47 Pcnt
1784678363	100 Pcnt	47 Pcnt
1784676562	100 Pcnt	47 Pcnt
1784674760	100 Pcnt	47 Pcnt
1784672958	100 Pcnt	47 Pcnt
1784671156	100 Pcnt	47 Pcnt
1784669355	100 Pcnt	47 Pcnt
1784667553	100 Pcnt	47 Pcnt
1784665751	100 Pcnt	47 Pcnt
1784663949	100 Pcnt	47 Pcnt
1784662148	100 Pcnt	47 Pcnt
1784660346	100 Pcnt	47 Pcnt
1784658544	100 Pcnt	47 Pcnt
1784656742	100 Pcnt	47 Pcnt
1784654941	100 Pcnt	47 Pcnt

*Used Equation Coefficients:

Rx1h: 0, 10, 0

Digi1h: 0, 10, 0

Eff1h: 0, 1, 0

Efftot: 0, 1, 0

Volt: 0, 0.079, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)