SQ9IDT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IDT-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789970782	81 Count	499 Count	78 Count
1789968947	63 Count	335 Count	61 Count
1789967146	51 Count	235 Count	50 Count
1789965346	27 Count	119 Count	27 Count
1789963545	321 Count	1020 Count	306 Count
1789961744	288 Count	931 Count	274 Count
1789959944	257 Count	836 Count	244 Count
1789958158	209 Count	707 Count	201 Count
1789956357	180 Count	618 Count	173 Count
1789954557	147 Count	515 Count	141 Count
1789952756	119 Count	417 Count	114 Count
1789950955	89 Count	315 Count	85 Count
1789949154	60 Count	214 Count	57 Count
1789947353	28 Count	101 Count	28 Count
1789945553	296 Count	1028 Count	287 Count
1789943752	267 Count	944 Count	259 Count
1789941952	234 Count	842 Count	227 Count
1789940151	203 Count	747 Count	197 Count
1789938350	174 Count	635 Count	169 Count
1789936550	145 Count	525 Count	141 Count
1789934749	114 Count	417 Count	111 Count
1789932948	85 Count	309 Count	83 Count
1789931148	55 Count	208 Count	54 Count
1789929347	28 Count	109 Count	28 Count
1789927546	164 Count	1024 Count	153 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)