SQ2MO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1788598741	69 Count	676 Count	13 Count
1788598140	68 Count	669 Count	13 Count
1788597539	67 Count	662 Count	13 Count
1788596938	66 Count	658 Count	13 Count
1788596338	65 Count	646 Count	13 Count
1788595737	64 Count	637 Count	13 Count
1788595136	63 Count	632 Count	13 Count
1788594535	62 Count	604 Count	13 Count
1788593935	61 Count	585 Count	13 Count
1788593334	60 Count	566 Count	13 Count
1788592733	56 Count	551 Count	10 Count
1788592132	55 Count	532 Count	10 Count
1788591532	54 Count	519 Count	10 Count
1788590931	53 Count	509 Count	10 Count
1788590330	52 Count	497 Count	10 Count
1788589729	50 Count	480 Count	9 Count
1788588528	48 Count	457 Count	9 Count
1788587927	47 Count	449 Count	9 Count
1788587326	40 Count	432 Count	3 Count
1788586726	39 Count	419 Count	3 Count
1788586125	38 Count	407 Count	3 Count
1788585524	37 Count	391 Count	3 Count
1788584923	36 Count	380 Count	3 Count
1788584322	35 Count	372 Count	3 Count
1788583722	34 Count	362 Count	3 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)