GW3ATZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object GW3ATZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1757609807	279 Count	891 Count	222 Count
1757606198	270 Count	859 Count	215 Count
1757602589	260 Count	831 Count	207 Count
1757598980	250 Count	801 Count	199 Count
1757595371	240 Count	773 Count	191 Count
1757591813	232 Count	743 Count	185 Count
1757588204	222 Count	708 Count	177 Count
1757584595	215 Count	673 Count	172 Count
1757580987	207 Count	657 Count	166 Count
1757577378	199 Count	641 Count	160 Count
1757573769	189 Count	614 Count	152 Count
1757570214	179 Count	581 Count	144 Count
1757566605	170 Count	545 Count	137 Count
1757562996	160 Count	507 Count	129 Count
1757559388	150 Count	472 Count	121 Count
1757555779	140 Count	440 Count	113 Count
1757552170	130 Count	406 Count	105 Count
1757548612	121 Count	370 Count	98 Count
1757545003	110 Count	341 Count	89 Count
1757541394	100 Count	309 Count	81 Count
1757537785	90 Count	282 Count	73 Count
1757534177	80 Count	250 Count	65 Count
1757530568	70 Count	210 Count	57 Count
1757527011	60 Count	177 Count	49 Count
1757523402	50 Count	148 Count	41 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)