VE1NWC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE1NWC-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value4*	Value5*
1789950804	527	512	511	111
1789948996	527	512	510	112
1789944783	529	509	511	111
1789942371	528	513	511	112
1789941161	529	534	512	113
1789939958	529	534	512	113
1789938153	528	534	511	112
1789936949	530	535	514	112
1789935743	537	589	520	112
1789933931	569	745	552	113
1789930921	571	579	553	113
1789929717	567	756	551	114
1789928513	568	757	551	113
1789926101	571	578	553	113
1789924898	542	550	525	113
1789923688	539	547	522	112
1789922484	535	542	518	112
1789921275	544	554	526	113
1789918866	538	547	521	113
1789917664	546	560	528	112
1789916461	540	548	522	112
1789914057	540	551	523	112
1789911042	537	544	518	111
1789910442	534	543	518	111
1789909842	533	540	515	111

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)