G0DUB-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object G0DUB-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1781895409	232 Count	339 Count	219 Count
1781893606	221 Count	328 Count	209 Count
1781891803	211 Count	317 Count	200 Count
1781890000	201 Count	307 Count	191 Count
1781888230	188 Count	293 Count	179 Count
1781886427	180 Count	285 Count	172 Count
1781884624	171 Count	275 Count	164 Count
1781882821	154 Count	255 Count	148 Count
1781881018	142 Count	243 Count	137 Count
1781879215	118 Count	216 Count	114 Count
1781877411	109 Count	208 Count	106 Count
1781875608	100 Count	200 Count	98 Count
1781873805	87 Count	183 Count	86 Count
1781872002	75 Count	163 Count	75 Count
1781870199	66 Count	147 Count	67 Count
1781868396	51 Count	110 Count	53 Count
1781865649	22 Count	44 Count	26 Count
1781863898	12 Count	29 Count	17 Count
1781807781	0 Count	4 Count	4 Count
1781807673	0 Count	4 Count	4 Count
1781807482	0 Count	4 Count	4 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)