DG1MJG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG1MJG-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1787566854	271 Count	193 Count
1787566251	270 Count	193 Count
1787565647	269 Count	193 Count
1787565044	268 Count	193 Count
1787564441	267 Count	193 Count
1787563838	266 Count	192 Count
1787563235	265 Count	192 Count
1787562631	264 Count	191 Count
1787562028	263 Count	190 Count
1787561425	262 Count	190 Count
1787560822	261 Count	189 Count
1787560219	260 Count	189 Count
1787559615	259 Count	189 Count
1787559012	258 Count	189 Count
1787558409	257 Count	189 Count
1787532895	257 Count	189 Count
1787532726	256 Count	189 Count
1787532122	255 Count	186 Count
1787531519	254 Count	184 Count
1787530916	253 Count	184 Count
1787530313	252 Count	183 Count
1787529709	251 Count	181 Count
1787529105	250 Count	180 Count
1787528502	249 Count	176 Count
1787527899	248 Count	174 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)