ON4CDR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ON4CDR-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1784677028	100 Count	189 Count
1784676125	83 Count	149 Count
1784675299	66 Count	120 Count
1784674395	52 Count	89 Count
1784673492	33 Count	53 Count
1784672589	19 Count	16 Count
1784671686	407 Count	1001 Count
1784670783	392 Count	971 Count
1784669879	374 Count	928 Count
1784668974	358 Count	889 Count
1784668071	340 Count	851 Count
1784667168	326 Count	811 Count
1784666265	308 Count	779 Count
1784665362	294 Count	741 Count
1784664458	274 Count	706 Count
1784663555	259 Count	675 Count
1784662652	237 Count	643 Count
1784661749	223 Count	607 Count
1784660849	204 Count	564 Count
1784659943	202 Count	524 Count
1784659040	184 Count	489 Count
1784658137	170 Count	450 Count
1784657234	152 Count	420 Count
1784656331	138 Count	396 Count
1784655428	120 Count	358 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)