PD2SKZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PD2SKZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1761535467	213 Count	242 Count
1761531864	212 Count	242 Count
1761528260	211 Count	242 Count
1761524657	210 Count	242 Count
1761521053	209 Count	242 Count
1761517472	208 Count	242 Count
1761513869	207 Count	242 Count
1761510265	206 Count	242 Count
1761506662	205 Count	242 Count
1761503058	204 Count	242 Count
1761499454	203 Count	242 Count
1761495871	202 Count	242 Count
1761488663	200 Count	242 Count
1761485059	199 Count	242 Count
1761481456	198 Count	241 Count
1761477852	197 Count	240 Count
1761474270	196 Count	240 Count
1761470666	195 Count	240 Count
1761467062	194 Count	239 Count
1761463458	193 Count	239 Count
1761459855	192 Count	239 Count
1761456251	191 Count	239 Count
1761452669	190 Count	239 Count
1761449065	189 Count	239 Count
1761445461	188 Count	239 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)