DG0JDE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG0JDE-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789954347	886 Count	85 Count
1789952546	885 Count	85 Count
1789950745	884 Count	85 Count
1789947143	882 Count	85 Count
1789945351	881 Count	85 Count
1789943550	880 Count	85 Count
1789941749	879 Count	85 Count
1789939948	878 Count	85 Count
1789938147	877 Count	85 Count
1789936346	876 Count	85 Count
1789934545	875 Count	85 Count
1789932745	874 Count	85 Count
1789930944	873 Count	85 Count
1789929143	872 Count	85 Count
1789927342	871 Count	85 Count
1789925541	869 Count	85 Count
1789923750	868 Count	85 Count
1789921949	867 Count	85 Count
1789920148	866 Count	85 Count
1789918347	865 Count	85 Count
1789916546	864 Count	85 Count
1789914745	863 Count	85 Count
1789912944	862 Count	85 Count
1789911143	861 Count	85 Count
1789909343	860 Count	85 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)