PU1PZP-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PU1PZP-15. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1785323575	20	53	164	10	138
1785322968	20	53	164	11	138
1785322356	20	53	164	12	134
1785321748	20	54	164	12	138
1785321140	20	53	164	8	138
1785320537	20	53	164	9	138
1785319930	20	54	164	11	138
1785319324	20	55	164	12	138
1785318716	20	55	164	11	138
1785318105	20	56	164	9	138
1785317500	20	56	164	5	138
1785316292	20	55	164	9	135
1785315686	20	55	164	6	138
1785315082	20	53	164	11	138
1785314474	20	53	164	6	138
1785313872	20	52	164	5	138
1785313271	20	52	164	8	138
1785312665	20	52	164	6	138
1785312062	20	52	164	6	138
1785311460	20	53	164	14	138
1785310851	20	54	164	6	138
1785310249	20	55	164	5	138
1785309646	20	56	164	11	138
1785309038	20	56	164	9	138
1785308432	21	57	164	5	138

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)