SR9WXZ Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9WXZ. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Rx10min*	Vbatt*
1776672183	14 Pkt	13.32 V
1776670980	12 Pkt	13.24 V
1776670379	14 Pkt	13.2 V
1776669779	11 Pkt	13.22 V
1776669175	11 Pkt	13.32 V
1776668575	11 Pkt	13.42 V
1776667975	5 Pkt	13.5 V
1776667374	8 Pkt	13.08 V
1776666774	6 Pkt	12.9 V
1776666160	5 Pkt	12.88 V
1776665560	8 Pkt	12.86 V
1776664959	6 Pkt	12.84 V
1776663757	4 Pkt	12.8 V
1776663156	1 Pkt	12.84 V
1776662553	1 Pkt	12.88 V
1776661952	1 Pkt	12.88 V
1776661352	2 Pkt	12.86 V
1776660752	1 Pkt	12.82 V
1776660151	5 Pkt	12.78 V
1776659551	9 Pkt	12.78 V
1776658951	12 Pkt	12.8 V
1776658350	12 Pkt	12.8 V
1776657149	11 Pkt	12.82 V
1776656539	17 Pkt	12.78 V
1776655935	12 Pkt	12.8 V

*Used Equation Coefficients:

Rx10min: 0, 1, 0

Visc10min: 0, 1, 0

Digi10min: 0, 1, 0

Vbatt: 0, 0.02, 10

Tempre: 0, 0.5, -50

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)