PE1PMD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PE1PMD-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787604643	211 Count	795 Count	161 Count
1787603740	209 Count	771 Count	160 Count
1787602836	207 Count	750 Count	159 Count
1787601932	203 Count	725 Count	156 Count
1787601028	201 Count	698 Count	155 Count
1787600125	199 Count	687 Count	154 Count
1787599301	196 Count	670 Count	152 Count
1787598398	193 Count	657 Count	150 Count
1787597494	190 Count	634 Count	148 Count
1787596590	186 Count	620 Count	145 Count
1787595687	183 Count	607 Count	143 Count
1787594783	180 Count	588 Count	141 Count
1787593880	177 Count	573 Count	139 Count
1787592976	174 Count	560 Count	137 Count
1787592072	170 Count	539 Count	134 Count
1787591168	167 Count	523 Count	132 Count
1787590265	164 Count	511 Count	130 Count
1787589361	161 Count	494 Count	128 Count
1787588458	160 Count	484 Count	128 Count
1787587554	158 Count	468 Count	127 Count
1787586651	156 Count	453 Count	126 Count
1787585747	154 Count	439 Count	125 Count
1787584844	151 Count	418 Count	123 Count
1787583940	148 Count	403 Count	121 Count
1787583036	145 Count	388 Count	119 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)