XE2XEH-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XE2XEH-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*
1787550902	870	145	79
1787550604	780	119	86
1787550303	870	255	86
1787550002	870	137	94
1787549402	870	255	96
1787549104	520	22	79
1787548803	560	91	79
1787548503	700	102	76
1787547904	650	119	104
1787547603	580	20	99
1787547389	870	255	86
1787546704	760	58	102
1787546403	650	38	102
1787545803	760	56	91
1787464505	830	244	168
1787463304	820	168	204
1787463005	810	255	196
1787462404	840	119	196
1787462105	730	255	196
1787461504	850	255	186
1787461204	890	178	178
1787460904	890	127	173
1787460605	840	244	224
1787460305	780	214	224
1787460004	880	84	224

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)