This is the latest recevied telemetry packets stored in our database for station/object DM7PM-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
TX*
RX*
Digi*
V_Bat*
V_Ext*
1788701231
95 Count
382 Count
10 Count
4.17 VDC
0 VDC
1788699428
94 Count
382 Count
10 Count
4.23 VDC
0 VDC
1788697625
93 Count
382 Count
10 Count
4.25 VDC
0 VDC
1788695822
92 Count
382 Count
10 Count
4.19 VDC
0 VDC
1788694019
91 Count
382 Count
10 Count
4.26 VDC
0 VDC
1788692216
90 Count
382 Count
10 Count
4.2 VDC
0 VDC
1788690413
89 Count
382 Count
10 Count
4.17 VDC
0 VDC
1788626310
88 Count
382 Count
10 Count
4.26 VDC
0 VDC
1788624507
87 Count
382 Count
10 Count
4.25 VDC
0 VDC
1788622704
86 Count
382 Count
10 Count
4.23 VDC
0 VDC
1788620901
85 Count
382 Count
10 Count
4.17 VDC
0 VDC
1788620810
84 Count
382 Count
10 Count
4.26 VDC
0 VDC
*Used Equation Coefficients:
TX: 0, 1, 0
RX: 0, 1, 0
Digi: 0, 1, 0
V_Bat: 0, 0.01, 0
V_Ext: 0, 0.02, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)