N0BCB-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N0BCB-6. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1784690580	131	72	255	183	149
1784689981	131	72	255	183	149
1784689381	131	72	255	183	149
1784688780	131	72	255	183	149
1784688181	131	72	255	183	149
1784687578	131	71	255	183	149
1784686977	131	71	255	184	149
1784686377	131	71	255	184	149
1784685177	131	71	255	184	149
1784684577	131	71	255	183	149
1784683978	131	72	255	183	149
1784683378	131	73	255	183	149
1784682779	131	74	255	183	148
1784682176	131	75	255	182	148
1784681576	131	76	255	182	147
1784680974	131	78	255	181	146
1784680375	131	82	255	180	144
1784679775	132	86	255	179	142
1784679175	132	92	255	177	140
1784678577	133	98	255	176	138
1784677974	134	100	255	176	137
1784677373	135	102	255	175	136
1784676777	135	104	255	174	135
1784676173	135	105	255	174	135
1784675577	135	108	255	173	134

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)