OE5MIL-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE5MIL-13. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Temp*
1780533883	12.9 Volt	8 C
1780532682	12.9 Volt	8 C
1780531481	12.98 Volt	8 C
1780530280	12.98 Volt	8 C
1780529079	12.98 Volt	8 C
1780527877	12.98 Volt	8 C
1780526676	12.98 Volt	8 C
1780525475	12.98 Volt	8 C
1780524274	12.98 Volt	8 C
1780523073	13.05 Volt	8 C
1780521872	13.05 Volt	8 C
1780520670	13.05 Volt	8 C
1780519469	13.05 Volt	8 C
1780518268	13.05 Volt	8.5 C
1780517067	13.05 Volt	8.5 C
1780515866	13.05 Volt	8.5 C
1780514665	13.13 Volt	8.5 C
1780513464	13.13 Volt	8.5 C
1780512262	13.2 Volt	8.5 C
1780511061	13.28 Volt	8.5 C
1780509860	13.43 Volt	8.5 C
1780508659	13.65 Volt	8.5 C
1780507458	14.48 Volt	8.5 C
1780506257	14.33 Volt	8.5 C
1780505056	14.33 Volt	8.5 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Temp: 0, 0.5, -64

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)