YO9ABK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YO9ABK-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp_exterioara*	Value2*	Value3*	Value4*	Value5*
1772724671	10.3 C	0	0	0	0
1772724071	10.4 C	0	0	0	0
1772723471	10.6 C	0	0	0	0
1772722272	10.9 C	0	0	0	0
1772721071	12.1 C	0	0	0	0
1772720471	12.4 C	0	0	0	0
1772719883	12.8 C	0	0	0	0
1772719271	12.3 C	0	0	0	0
1772718671	11.6 C	0	0	0	0
1772717471	11.4 C	0	0	0	0
1772716871	11.9 C	0	0	0	0
1772716271	11.9 C	0	0	0	0
1772714471	11.6 C	0	0	0	0
1772713871	11.6 C	0	0	0	0
1772712671	11.8 C	0	0	0	0
1772712076	12.1 C	0	0	0	0
1772711471	12.6 C	0	0	0	0
1772710871	13.2 C	0	0	0	0
1772710272	13.1 C	0	0	0	0
1772709671	13.7 C	0	0	0	0
1772709073	15.2 C	0	0	0	0
1772708471	14.8 C	0	0	0	0
1772707871	15.4 C	0	0	0	0
1772707271	14.9 C	0	0	0	0
1772706671	14.6 C	0	0	0	0

*Used Equation Coefficients:

Temp_exterioara: 0, 1, -100

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)