SQ2CPA-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-4. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1784704263	147 Count	357 Count
1784702462	142 Count	339 Count
1784700661	138 Count	334 Count
1784698861	134 Count	329 Count
1784697060	130 Count	324 Count
1784695259	126 Count	319 Count
1784693458	122 Count	314 Count
1784691658	118 Count	309 Count
1784689857	114 Count	299 Count
1784688056	111 Count	295 Count
1784686266	107 Count	290 Count
1784684465	103 Count	284 Count
1784682664	99 Count	278 Count
1784680864	95 Count	271 Count
1784679063	91 Count	265 Count
1784677262	87 Count	260 Count
1784675461	83 Count	255 Count
1784673661	79 Count	250 Count
1784671860	75 Count	245 Count
1784670059	71 Count	240 Count
1784668258	67 Count	235 Count
1784666458	63 Count	230 Count
1784664663	59 Count	226 Count
1784662863	55 Count	221 Count
1784661062	51 Count	216 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)