OK0HCS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK0HCS-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789944514	8 Count	735 Count
1789942711	7 Count	663 Count
1789940907	6 Count	588 Count
1789939104	5 Count	508 Count
1789937301	4 Count	427 Count
1789935535	3 Count	342 Count
1789933731	2 Count	259 Count
1789931928	1 Count	167 Count
1789930125	0 Count	76 Count
1789928322	16 Count	1016 Count
1789926519	12 Count	932 Count
1789924716	10 Count	844 Count
1789922913	9 Count	749 Count
1789921110	8 Count	640 Count
1789919307	7 Count	558 Count
1789917504	6 Count	462 Count
1789915701	5 Count	351 Count
1789913934	4 Count	271 Count
1789912131	1 Count	152 Count
1789910328	0 Count	71 Count
1789908525	15 Count	1023 Count
1789906722	14 Count	932 Count
1789904919	12 Count	834 Count
1789903115	11 Count	759 Count
1789901312	10 Count	687 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)